Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 22-19

You can now optionally configure the virtual router port that this 

VLAN

 will use to communi-

cate with other AutoTracker 

VLAN

s. A virtual router port for the 

VLAN

 is created within the 

switch. If you do not define a virtual router port for this 

VLAN

, devices within the 

VLAN

 will 

only be able to communicate with devices in other 

VLAN

s through an external router.

You will have the choice of configuring 

IP

, 

IPX

, or both 

IP

 and 

IPX

 routing. Continue with the 

steps below:

1. After you finish configuring AutoTracker Policies for this 

VLAN

, the following prompt 

displays:

Press 

 if you want to enable IP Routing on this virtual router port. If you do not 

enable IP, then this 

VLAN

 will not be able to internally route IP data. If you don’t want to 

set up the IP router port, enter 

, press 

You may enable routing of both 

IP

 and 

IPX

 traffic on 

this router port. If you set up dual-protocol routing, you 
must fill out information for both 

IP

 and 

IPX

 parame-

ters.

2. The following prompt displays:

Enter the IP address for this virtual router port in dotted decimal notation or hexadecimal 
notation (e.g., 198.206.181.10). This IP address is assigned to the virtual router port for 
this 

VLAN

. After you enter the address, press 

.

3. The following prompt displays:

The default IP subnet mask (in parentheses) is automatically derived from the 

VLAN

’s IP 

address class. Press 

 to select the default subnet mask or enter a new subnet mask 

in dotted decimal notation or hexadecimal notation and press 

. 

4. The following prompt displays:

The default IP broadcast address (in parentheses) is automatically derived from the 

VLAN

’s 

IP address class. Press 

 to select the default address or enter a new IP broadcast 

address in dotted decimal notation or hexadecimal notation and press 

. 

5. The following prompt displays:

Enter a useful description for this virtual IP router port using alphanumeric characters. The 
description may be up to 30 characters long. Press 

.

6. The following prompt displays:

Indicate whether you want to disable routing in the 

VLAN

. You can enable routing later 

through the 

 command.