Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 22-18

You can define AutoTracker policies by port, 

MAC

 address, protocol, network address, user 

definition, or port binding. You can define multiple policies for a AutoTracker 

VLAN

 

if you 

wish. A port or device is included in a AutoTracker 

VLAN

 if it matches any one rule. For 

example, you can define rules based on ports, rules based on 

MAC

 address, and rules based 

on protocol in the same AutoTracker 

VLAN

. However, defining multiple rules is not trivial – 

exercise extreme care when you do so and make sure that you understand the consequences 
of your definitions. In most situations, it is advisable to use one of AutoTracker’s predefined 
rules.

Instructions for defining each AutoTracker policy type are included in Chapter 20, “Configur-
ing Group and VLAN Policies.” Follow the directions in that chapter for the policy you wish 
to set up.

The sections below provide directions for setting up each type of AutoTracker policy. Follow 
the directions for the policy you wish to set up.

1. When are done specifying AutoTracker policies the following prompt displays:

You can set up multiple rules for the same 

VLAN

. Enter a 

 here if you want to set up 

more rules in addition to the Network Address rule specified here. If you enter 

, you will 

be prompted for the next rule that you want to set up on this 

VLAN

. Follow the directions 

in the appropriate section to configure that rule.

If you enter 

, you will receive a message, similar to the one below, indicating that the 

VLAN

 was set up.

You are done setting up rules for this 

VLAN

, so you can start configuring the virtual router 

for this 

VLAN

information on configuring a virtual router port.