Sony STRDN1020 사용자 설명서

D:\NORM'S JOB\SONY HA\SO0155\STR-DN1020_PMRF 03\4273051141_GB\GB04GET_STR-
DN1020-CEL.fm

STR-DN1020

4-273-051-14(1)

 

V/v repeatedly to select 

b.

B/b repeatedly to select 

The calibration type is automatically set 
to “Engineer”.

The measurement process will take 
approximately 30 seconds with a test 
tone.
When the measurement ends, a beep 
sounds and the screen switches.

If an error code appears on the screen, see 
“Message list after Auto Calibration 
measurement” (page 42).

V/v repeatedly to select 

• Retry: Performs the Auto Calibration 

again.

• Save: Save the measurement results and 

exits the setting process.

• Warning: Displays warning related to 

the measurement results. See “Message 
list after Auto Calibration 
measurement” (page 42).

• Exit: Exits the setting process without 

saving the measurement results.

Select “Save” in step 7.

• You can select the calibration type you want 

by using the “Custom” Auto Calibration 

 

• The A.P.M. (Automatic Phase Matching) 

function is activated after you save the 
measurement result. 

• The A.P.M. (Automatic Phase Matching) 

function does not work in the following cases.  
– The calibration type is set to “Off” when 

using the “Custom” Auto Calibration 

 

(page 43).  

– When Dolby TrueHD or DTS-HD signals 

with a sampling frequency of more than 
48 kHz are being received.

If you reposition your speaker, we recommend that 
you perform Auto Calibration again to enjoy the 
surround sound.

• You can change the unit of distance in “Distance 

Unit” in the Speaker settings menu (page 94).

• The size of a speaker (“Large”/“Small”) is 

determined by the low frequency characteristics. 
The measurement results may vary, depending on 
the position of the optimizer microphone and 
speakers, and the shape of the room. It is 
recommended that you apply the measurement 
results. However, you can change those settings in 
the Speaker Settings menu. Save the measurement 
results first, then try to change the settings.