Sony STRDN1020 사용자 설명서

D:\NORM'S JOB\SONY HA\SO0155\STR-DN1020_PMRF 03\4273051141_GB\GB04GET_STR-
DN1020-CEL.fm

STR-DN1020

4-273-051-14(1)

The Auto Calibration function will be 
canceled when you perform the following 
during the measurement process:
– Press ?/1.
– Press the input buttons on the remote control 

or turn the INPUT SELECTOR on the 
receiver.

– Press MUTING or 

.

– Press SPEAKERS on the receiver.
– Change the volume level.
– Connect the headphones.
– Press SHIFT, then press AUTO CAL.

To check error code or warning message 
obtained in “Performing Auto Calibration” 
(page 40), proceed with the following steps.

V/v to select “Warning” in 

step 7 in “Performing Auto 
Calibration” (page 41) then press 

If a warning message appears, check the 
message and use the receiver without change.
Or if necessary, perform Auto Calibration 
again.

Check the error and perform Auto Calibration 
again.

Press 

 to select “ENTER”.

“RETRY ?” appears on the TV screen.

Press 

B/b to select “YES”, then press 

.

Repeat steps 6 to 9 in “Performing Auto 
Calibration” (page 40).

Depending on the position of the subwoofer, the 
measurement results may vary. However, there will 
be no problems even if you continue to use the 
receiver with that value.

Error Code 31
The SPEAKERS is set to off. Set to other speaker 
settings and perform the Auto Calibration again.

Error Code 32
None of the speakers were detected. Make sure that 
the optimizer microphone is connected properly 
and perform the Auto Calibration again. 
If the optimizer microphone is connected properly 
but the error code still appears, the optimizer 
microphone cable may be damaged.

Error Code 33
• None of the front speakers are connected or only 

one front speaker is connected.

• The optimizer microphone is not connected.
• Either the surround left or surround right speaker 

is not connected.

• Surround back speakers or front high speakers are 

connected even though surround speakers are not 
connected. Connect the surround speaker(s) to the 
SPEAKERS SURROUND terminals.

• The surround back speaker is connected only to 

the SPEAKERS SURROUND BACK/FRONT 
HIGH/BI-AMP/FRONT B R terminals. When 
you connect only one surround back speaker, 
connect it to the SPEAKERS SURROUND 
BACK/FRONT HIGH/BI-AMP/FRONT B L 
terminals.

• Either the front left high or front right high 

speaker is not connected.

Warning 40
The measurement process has completed with high 
noise level detection. You may be able to achieve 
better results if you try in a quiet environment again.

Warning 41
Warning 42
The input from the microphone is too big.
• The distance between the speaker and the 

microphone may be too close. Set them apart and 
perform the measurement again.

Warning 43
The distance and position of a subwoofer cannot be 
detected. This may be caused by noise. Try to 
perform the measurement in a quiet environment.

No Warning
There is no warning information.