Epson 7000 사용자 설명서

1.

Remove the R Side Cover as described in “R Side Cover Removal” on 
page 114.

2.

Remove the L Side Cover as described in “L Side Cover Removal” on 
page 116.

3.

Remove the Rear Cover as described in “Rear Cover Removal” on 
page 118.

4.

Remove the CR Motor cable from the C299MAIN board connector (refer to 
Table 4-4, “C299MAIN Board Connectors,” on page 123 for details) and 
harness clamps. Then pull out the cable through the L Side frame 
opening.

5.

Push down the cutter to release the CR lock and move the carriage away 
from the home position.

6.

Loosen the CR Tension shaft on the right side of the printer to release the 
tension on the CR Timing belt.

7.

Pull off the CR Timing Belt from the CR Motor pulley on the left side of the 
printer.

8.

Remove the four screws (CP(W) M4x10) securing the CR motor and 
remove the CR motor.

Before loosening the CR timing belt tension, confirm and write 
down the current tension. See “CR Timing Belt Tension 
Adjustment” on page 198 for information on confirming the 
tension.

„

“CR Timing Belt Tension Adjustment” on page 198