Epson 7000 사용자 설명서

The Adjust menu allows you to make certain adjustments to the printer 
mechanism and controls, for example head angle adjustment, print position 
adjustment, paper feeding correction, and firmware-control setting.

Capping Position

Sets the Capping position (automatic Adjustment)

Paper Skew Check

Verifies the degree of skew (slant) allowed during 
printing

Write D/A Value

Writes the direct/alternate data to the Flash ROM; 
compensates for differences in individual Main Boards - 
like head ID for the Main Board

Head Rank Input

Sets the printhead ID

Head Nozzle Check

Prints the check pattern to make sure the nozzles are not 
clogged

B Head Angle

Adjusts the angle of the B Head (mechanism adj.)

C Head Angle

Adjusts the angle of the C Head (mechanism adj.)

BC Head Height

Verifies the B/C Head nozzles are at the same height 
(mechanism adj.)

Bi-D Print Position

Verifies the printed lines match up when performing bi-
directional printing.

Head Gap

Adjusts the B/C Head Gap as well as sets the left margin

R Flush Point

Adjusts the flush position on the HP side

L Flush Point

Do not use, there is no left flush point and this function 
will generate a fatal error.

Feed Correction

Checks paper feeding (w/ruler)

Top & Bottom

Checks the top and bottom margins (w/ruler)

Rear Paper Sensor 
Position

Sets the detection position of the rear paper-edge sensor

Test Pattern Print

Checks print quality (prints setting information, check 
pattern and so on)

Clean Head

Initiates cleaning/flushing of the heads and ink path

1) Ink drain

2) Fill with transportation fluid (1 time = 15ml)

3) Drain transportation fluid

4) Reset the ink charge flag

Counter Clear

Resets all counters in Table 5-14 on page 194

„

„