Epson 7000 사용자 설명서

This function sets the distances between the P FRONT sensor and heads, 
cutter and heads, as well as the P EDGE sensor and heads. You can also use 
this function to adjust the top, bottom, and side margins.

1.

Make sure "Adj. Top & Bottom" appears, and press the Enter button.

2.

The printer prints a check pattern (lines) and cuts off the paper at a fixed 
distance.

3.

After the printing operation is finished, measure the top, bottom, and 
right (HP) side margins using a ruler. Press the item select (Paper Feed) +/
- buttons to enter each of these measurements in 0.1mm increments.

4.

After entering the measurements, press the SelecType or Item button 
until "Bottom Length xx.xmm" appears, and then press the Enter button.