Epson 7000 사용자 설명서

This function makes sure the P REAR sensor correctly detects the rear edge of 
cut-sheet paper to allow the user to print with the largest possible printable 
area but without printing off the edge of the paper and marring future 
printouts. The printer prints an A3-size test pattern. Using a ruler, measure 
the distance from the rear edge of the pattern to the rear edge of the paper, 
and then enter this measurement when prompted. This value is stored in the 
printer’s firmware to be referenced against the printhead nozzle position.

1.

Make sure "Adj Rear Sensor Pos." appears, and press the Enter button.

2.

Load A3-size paper in portrait (short edge first) orientation when you see 
the "Please Set CutSheet" message. After the paper initializes, press the 
Enter button to print the check pattern.

3.

After printing is finished, measure the distance from the rear edge of the 
printed pattern to the rear edge of the paper. Press the Enter button until 
you see "RearSen. Pos. xx.xmm", and then enter the measurement in 
increments of 0.1mm using the item select (Paper Feed) +/- buttons. After 
entering the measurement, press the Enter button.