Epson 7000 사용자 설명서

5.

Press Item and confirm that “THICK. PAT. = Print” appears on the display. 
Then press Enter to print the paper thickness pattern.

6.

Select the number of the most vertically aligned pair of lines, and press 
Enter. (#5 is correct in the example below).

If necessary, select Drying Time from the Paper Config menu to select an 
automatic period of time that the printer will pause printing to let the 
previously printed sheet dry. Also, to prevent thin or light paper from getting 
stuck over the paper suction holes in the Lower Paper Guide, you can select 
Low (50% power) as the Suction setting.

Print the Status Sheet from the Test Print menu in SelecType mode and see 
page 43 for information on determining when the cutter needs to be replaced.

The following table includes the steps/messages that must be followed to 
replace the cutter.

If you need to replace the cutter:

1.

Press the SelecType button until CUTTER REPLACE MENU appears on the 
LCD. (You can automatically enter the cutter replacement menu by 
pressing the SelecType button for five seconds.)

2.

Open the Lower Cover (as shown on the LCD).

3.

While pushing down the cutter (the lower of the two extensions on the 
left), slide the cutter actuator extension up and to the right.

4.

Remove the old cutter and replace with a new one.

5.

Close the Lower Cover (as shown on the LCD).

CUTTER REPLACE MENU Prepare a replacement cutter and

OPEN LOWER COVER

Open the front cover.

REPLACE CUTTER

Push down on the cutter itself and 
move the cap (actuator) to the right. 
Remove the old cutter and install a 
new one. Make sure the cap is 
correctly replaced over the cutter.

CLOSE LOWER COVER

Close the front cover. The printer is 
ready and the cutter counter is 
automatically reset.