Intermec PF4i 사용자 설명서
112
Intermec EasyCoder PF4i Compact Industrial—User’s Guide (Fingerprint)
Chapter 12—Adjustments
Printhead Pressure
The pressure of the thermal printhead against the direct thermal media
is factory-adjusted. However, the use of thicker or thinner media than
normal could require the printhead pressure to be readjusted.
is factory-adjusted. However, the use of thicker or thinner media than
normal could require the printhead pressure to be readjusted.
Using a straight-slot screwdriver, turn the adjustment screw clockwise for
more pressure (+) or counterclockwise for less pressure (-). Print a few
labels, preferably test labels (see Chapter 6, “Setting Up the Printer”) and
check the printout. Increased pressure generally gives a darker printout
and vice versa. Repeat until the desired result is obtained.
more pressure (+) or counterclockwise for less pressure (-). Print a few
labels, preferably test labels (see Chapter 6, “Setting Up the Printer”) and
check the printout. Increased pressure generally gives a darker printout
and vice versa. Repeat until the desired result is obtained.
To return to the factory setting, tighten the screw (+) as far as it goes and
then loosen it (-) four full turns.
then loosen it (-) four full turns.
Do not use a higher printhead pressure than necessary,
because it may increase the wear of the printhead and
shorten its life.
because it may increase the wear of the printhead and
shorten its life.
Adjustment screw