Intermec PF4i 사용자 설명서

If ribbon wrinkling occurs, you may need to adjust the alignment of the 
front ribbon break shaft so that it runs parallel to the printhead and the 
ribbon supply and rewind hubs. The adjustment is done using a straight-
slot screw that is located immediately behind the front ribbon break 
shaft.

•  If the ribbon tends to slide outwards, turn the screw carefully clock-

wise (fw) to move the outer end of the break shaft forward.

•  If the ribbon tends to slide inwards, turn the screw carefully counter-

clockwise (bw) to move the outer end of the break shaft backward.

Adjustment Screw

Ribbon Break Shaft