Intermec PF4i 사용자 설명서

  Place the printer on a level surface, near an AC outlet. You should be 

able to access the printer to load supplies and to remove the printout.

  Check that the printer is switched off.

  Connect the power cord from the socket on the rear plate to an elec-

trical outlet (90 to 265 VAC).

The Easycoder PF4i Compact Industrial is fi tted with one 9-pin D-style 
subminiature (DB9) socket for the RS-232 serial interface port and one 
class B connector for the USB interface port (see Appendix C).  

Use the serial interface with Intermec LabelShop or the Intermec Inter-
Driver. Also use it with the Intermec Direct Protocol or the Intermec 
Fingerprint programming language because you can receive error mes-
sages from your printer. Before you can use the serial interface, you may 
need to set up the communication parameters, such as baud rate, parity, 
etc. as described in Chapter 6, “Setting Up the Printer.”

Use the USB interface with an USB-compatible version of the Intermec 
InterDriver for printing. The USB interface is not suitable for program-
ming because the host cannot receive error messages from your printer. 

Several types are available (see Chapter 9, “Options”). Refer to Chapter 
6, Chapter 7, and Appendix C for connection and setup instructions.

The printer can be set to scan all communication ports. When it detects 
incoming data on a port, the printer automatically switches to use that 
port for both input and output. This facility ("auto") can be selected in 
Intermec Shell (see Chapter 8) or using the Intermec Fingerprint instruc-
tion SETSTDIO, see Intermec Fingerprint v8.xx, Programmer’s Reference 
Manual. Use the <F5/i> key to get information on the active communi-
cation channels. 

Switch off both PC and printer before connecting them together.