IBM S544-5361-01 사용자 설명서

IBM Network Color Printer Operator’s Guide

 

 

1.

Run several full-color gradient test prints from the density control panel (see 
“Printing Test Prints from the Density Control Panel” on page 6–24).

• If the spots appear on 1 color only, replace the toner cartridge for that color 

(see “Replacing Toner Cartridges” on page 5–4).

• Otherwise, go to step 2.

2.

Replace the photoconductor drum cartridge (see “Replacing the 
Photoconductor Drum Cartridge” on page 5–33).

3.

Make sure that the paper loaded in the printer is free of excess moisture and 
meets the specifications listed in “Choosing Paper” on page 2–2.

4.

Clean the transfer drum (see “Cleaning the Transfer Drum” on page 8–3).

1.

Make sure that the paper loaded in the printer is free of defects and meets the 
specifications listed in “Choosing Paper” on page 2–2.

2.

Check the fuser rollers for flaws or dirt buildup.

• If you see flaws on the fuser rollers, replace the fuser unit (see “Replacing 

• If you see dirt on the fuser rollers, try to remove it using the procedure 

described in “Cleaning the Fuser Rollers” on page 8–5.

• If you cannot remove all of the dirt, replace the fuser unit.

1.

Make sure that the temperature and humidity of the room in which the printer 
is located are within the specifications described in the 

Installation and 

Relocation Guide

.

See the 

Installation and Relocation Guide

 for correct environmental values.

2.

Make sure that the printer is not subjected to vibration.