Genicom PC4 사용자 설명서
EasyCoder PC4 User’s Guide
11
Chapter 2 — Installation
Software Installation
If you intend to use the USB interface, you must start by installing the
Intermec USB printer driver, which is included on the CD-ROM that
comes with the printer.
If you run your EasyCoder PC4 from a PC under Windows 98/Me, or
If you run your EasyCoder PC4 from a PC under Windows 98/Me, or
Windows NT 4.0/W2000/XP, you may want to install the Intermec
InterDriver and the Intermec LabelShop START found on the CD-
ROM that comes with the printer.
If you use any other operating system than Windows, you will need
If you use any other operating system than Windows, you will need
to use the ESim protocol described in the Intermec ESim v6.XX, Pro-
grammer’s Reference Manual. (Intermec ESim also supports Windows.)
Updates and installation instructions are available at the Intermec home
page
http://www.intermec.com
.
Note:
There are different firmware for the 203.2 dpi (8 dots/
mm) and the 300 dpi (11.81 dots/mm) versions.