Zebra Technologies 3ULQWHUV 사용자 설명서

120

 Zebra 

XiIIIPlus Users Guide

Troubleshooting

If there is an error condition on the printer or the labels are not printing or advancing 
correctly, review the checklist below.

‰What type of labels are you using? Review the types of label and the print modes, 

.

‰Review the label- and ribbon-loading illustrations, starting with 

‰Check the position of the media sensor and move if necessary, as shown in 

Printhead pressure and the darkness setting affect print quality. If the darkness setting is 
too high for the labels and ribbon being used, it causes premature printhead wear. If the 
toggle pressure is not even, labels and ribbon may slip.

Toggle adjustment may be needed if printing is too light on one side or if thick labels 
are used. Make sure that the toggles are positioned properly. 

Both toggles should be positioned so they provide even pressure on the labels. The 
toggles are positioned by sliding them to the desired location. 

‡ If you are using a 90XiIIIPlus or 96XiIIIPlus printer, position the single toggle 

over the center of the labels. 

‡ All other printer models have two toggles. If the labels are too narrow to fit both 

toggles, position one toggle over the center of the labels and decrease the pressure 
on the unused toggle. 

If positioning the toggles properly does not solve the problem, adjust printhead 
pressure.

Print quality depends on the labels and ribbon used as well as the 

toggle pressure. Make sure your labels and ribbon are right for your application. 

‡ Direct thermal labels do not need ribbon. 
‡ Thermal transfer labels need thermal transfer ribbon.