Zebra Technologies 3ULQWHUV 사용자 설명서

다운로드
페이지 168
122
 Zebra 
XiIIIPlus Users Guide
Appendixes
Troubleshooting
0HGLDDQG5LEERQ6HQVRU&DOLEUDWLRQ
Media and ribbon sensor calibration is one of the most common adjustments to the 
printer settings. There are two different types of calibration that can be done by the 
printer.
Auto-calibration is done by the printer feeding media when the printhead has been 
closed and it is first turned on. The printer automatically sets the value it detects for the 
spaces between labels. This type of calibration also happens as part of both the sensor 
profile and media and ribbon calibration procedures.
Media and Ribbon Sensor Sensitivity Calibration resets the sensitivity of the 
sensors to detect correctly the media and ribbon you are using. Se
 for instructions. Changing the type of ribbon and/or 
media may require resetting the sensitivity of the media and ribbon sensors. When the 
sensors are at their new sensitivity, the printer performs a standard calibration. 
Indications that the sensitivity may need to be reset are:
• A CHECK RIBBON light on with the ribbon properly installed
• Non-continuous labels being treated as continuous labels.
3ULQWHU6HWWLQJV&DQ%H&KDQJHG
Printer settings can be controlled by your printer’s driver or label preparation software, 
as well as at the front panel of the printer. Some examples of ways or places to change 
the printer settings are:
‡ Front panel of the printer, as shown in 
.
‡ Zebra Universal Driver
‡ BAR-ONE
®
‡ PrintServer II Guide
Note • 
Before you begin this procedure, make sure that the maximum length is set 
to a value 1 in. (25.4 mm) greater than the length of the labels you are using. If the 
maximum length is set to a lower value, the calibration process assumes that 
continuous media is in the printer. See
information.