Zebra Technologies 3ULQWHUV 사용자 설명서
Appendixes
Troubleshooting
Zebra XiIIIPlus Users Guide
131
A label format was sent to the printer but not recognized. The DATA light flashes but
no printing occurs.
no printing occurs.
The printer fails to calibrate or detect the top of the label.
3ULQWHU'LDJQRVWLFV
Self tests give information about the condition of the printer. The most commonly used
are the Power-On and the CANCEL self test.
are the Power-On and the CANCEL self test.
3RZHU2Q6HOI7HVW
The Power-On Self Test (POST) is performed automatically each time the printer is
turned on. During either test sequence, the front panel LEDs light up and the LCD
monitors the progress of the POST. If the printer fails any of these tests,
turned on. During either test sequence, the front panel LEDs light up and the LCD
monitors the progress of the POST. If the printer fails any of these tests,
)$,/('
shows on the LCD. If this occurs, notify an authorized Zebra reseller.
&DXVH
6ROXWLRQ
The prefix and delimiter characters set
in the printer do not match the ones in
the label format.
in the printer do not match the ones in
the label format.
Verify the prefix and delimiter characters.
See
See
for the
requirements.
Incorrect data is being sent to the
printer.
printer.
Ensure that ZPL is being used.
Check the communication settings on the
Check the communication settings on the
computer. Ensure that they match the
printer settings.
printer settings.
&DXVH
6ROXWLRQ
The printer was not calibrated for the
label being used.
label being used.
Perform the calibration procedure in
.
The printer is configured for
continuous media.
continuous media.
Set the media type to non-continuous media.
The driver or software configuration is
not set correctly.
not set correctly.
Driver or software settings produce ZPL
commands that can overwrite the printer
configuration. Check the driver or software
media-related setting.
commands that can overwrite the printer
configuration. Check the driver or software
media-related setting.