Panasonic CF-31Q5AAX1M 사용자 설명서

Read Me First

Regulatory Information

For U.S.A.

Federal Communications Commission Radio Frequency

Interference Statement

Note: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential instal-

lation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interfer-

ence will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one

or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

Consult the Panasonic Service Center or an experienced

radio/TV technician for help.

Warning

To assure continued compliance, use only shielded interface

cables when connecting to a computer or peripheral. Also, any

changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to

operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including

interference that may cause undesired operation.

FCC RF Exposure Warning:

This equipment is provided with PC Card slot that could be

used with wireless transmitters, which will be specifically

recommended when they become available.

Other third-party wireless transmitters have not been RF

exposure evaluated for use with this computer and may not

comply with FCC RF exposure requirements.

This equipment complies with FCC radiation exposure limits

set forth for an uncontrolled environment.

This equipment has been approved for mobile operation,

and unless otherwise advised in separate supplemental

instructions for individual wireless transmitter(s), requires

minimum 20cm spacing be provided between antenna(s)

and all person’s body (excluding extremities of hands, wrist

and feet) during wireless modes of operation.

This equipment may not be co-located or operated with any

other antenna or transmitter.

This equipment is provided with external antenna

connector(s) for connection to optional Car Mounter or Port

Replicator for mobile external mounted antenna(s). Exter-

nal antenna(s) must be professionally installed and cannot

exceed recommended maximum antenna gain as described

in individual provided supplement instructions for wireless

transmitters.

For WLAN, the Car Mounter should be used with Radiall/

Larsen WLAN whip antenna, type NMO5E2400BKTNC

with 5dBi antenna gain or less. Also, user must maintain

minimum 20 cm spacing between external antenna(s) and

all person’s body (excluding extremities of hands, wrist and

feet) during wireless modes of operation.

25-M-5

This product is restricted to indoor use due to its operation in

the 5.15 to 5.25 GHz frequency range. FCC requires this prod-

uct to be used indoors for the frequency range 5.15 to 5.25 GHz

to reduce the potential for harmful interference to co-channel

Mobile Satellite systems. High power radars are allocated as

primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz

bands. These radar stations can cause interference with and/or

damage this product.

25-M-W

Responsible Party: Panasonic Corporation of North America

Two Riverfront Plaza

Newark, NJ 07102

Tel No:1-800-LAPTOP5 (1-800-527-8675)

6-M-1

FCC Regulation Notice for modem

This equipment contains a FCC approved modem.

1. This equipment complies with CFR47 Part 68 rules.

On the computer is a label that contains, among other infor-

mation, the FCC registration number and ringer equivalence

number (REN) for this equipment. If required, this informa-

tion must be provided to the telephone company.

2. An FCC compliant telephone cord and modular plug is

provided with this equipment. This equipment is designed to

be connected to the telephone network or premises wiring

using a compatible modular jack which is Part 68 compliant.

See Installation Instructions for details.

3. The REN is used to determine the quantity of devices which

may be connected to the telephone line. Excessive RENs

on the telephone line may result in the devices not ringing in

response to an incoming call. In most, but not all area, the

sum of RENs should not exceed five (5.0). To be certain of

the number of devices that may be connected to a line, as

determined by the total RENs, contact the local telephone

company.

4. If your telephone equipment cause harm to the telephone

network, the telephone company will notify you in advice that

temporary discontinuance of service may be required. But

if advice notice isn’t practical, the telephone company will

notify the customer as soon as possible. Also, you will be

advised of your right to file a complaint with the FCC if you

believe it is necessary.

5. The telephone company may take changes in its facilities,

equipment, operations or procedures that could affect the

operation of the equipment. If this happens the telephone

company will provide advance notice in order for you to

make necessary modifications to maintain uninterrupted

service.

6. If trouble is experienced with this equipment, for repair or

warranty information, please contact Panasonic Corpora-

tion of North America at DIAL TOLL FREE 1-800-LAPTOP5

(1-800-527-8675). If the equipment is causing harm to the

telephone network, the telephone company may request that

you disconnect the equipment until the problem is resolved.

7. There are no user serviceable parts contained in this equip-

ment.

8. This equipment may not be used on coin service provided

by the telephone company. Connection to party lines is sub-

ject to state tariffs.

CF-31mk4(DFQW5801YAT)_OI_US.indb 8

2013/06/12 12:48:15