Cannon 3035 사용자 설명서
Setting Up a Computer for Printing/Sending a Fax
3-34
3
Usin
g a
TCP/IP Netw
or
k
IMPORTANT
If you use LPD, enter one of the following in [LPR Queue Name] in the [Add Port]
dialog box of Canon LPR2:
dialog box of Canon LPR2:
- LP
The machine prints according to its spool settings. Normally enter <LP> as a print
queue.
queue.
- SPOOL
The machine prints only after spooling a print job on the hard disk, regardless of
its spool settings.
its spool settings.
- DIRECT
The machine prints without spooling a print job on the hard disk, regardless of its
spool settings.
spool settings.
Windows 2000/XP/Server 2003
The procedure below uses screens of Windows 2000 as an example.
■ Installing a New Driver
1
Install the driver.
Install the driver according to the following procedures indicated in the manual
for each driver:
for each driver:
•
If you want to use the PCL printer driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the
PCL Driver Guide
.
•
If you want to use the PS printer driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the
PS Driver Guide
.
•
If you want to use the UFR II printer driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the
UFR II Driver Guide
.
•
If you want to use the fax driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the
Fax Driver Guide
.
NOTE
•
The print application will be LPD and the print queue will be set to <LP> if the driver
has been installed according to the above procedures.
has been installed according to the above procedures.
•
This machine enables you to specify print queues other than <LP>. You can also
use Raw as the print application. For instructions on how to change the settings,
see "Changing the Port after Installing the Driver," on p. 3-35.
use Raw as the print application. For instructions on how to change the settings,
see "Changing the Port after Installing the Driver," on p. 3-35.