Cisco Systems 3560 사용자 설명서

For information about the output of the show power inline user EXEC command, see the command 
reference for this release. For more information about PoE-related commands, see the 

. For information about configuring voice 

VLAN, see 

When Cisco powered devices are connected to PoE ports, the switch uses Cisco Discovery Protocol 
(CDP) to determine the actual power consumption of the devices, and the switch adjusts the power 
budget accordingly. The CDP protocol works with Cisco powered devices and does not apply to IEEE 
third-party powered devices. For these devices, when the switch grants a power request, the switch adjusts 
the power budget according to the powered-device IEEE classification. If the powered device is a 
Class 0 (class status unknown) or a Class 3, the switch budgets 15,400 milliwatts for the device, 
regardless of the actual amount of power needed. If the powered device reports a higher class than its 
actual consumption or does not support power classification (defaults to Class 0), the switch can power 
fewer devices because it uses the IEEE class information to track the global power budget.

By using the power inline consumption wattage configuration command, you can override the default 
power requirement specified by the IEEE classification. The difference between what is mandated by 
the IEEE classification and what is actually needed by the device is reclaimed into the global power 
budget for use by additional devices. You can then extend the switch power budget and use it more 
effectively.

For example, if the switch budgets 15,400 milliwatts on each PoE port, you can connect only 24 Class 0 
powered devices. If your Class 0 device power requirement is actually 5000 milliwatts, you can set the 
consumption wattage to 5000 milliwatts and connect up to 48 devices. The total PoE output power 
available on a 24-port or 48-port switch is 370,000 milliwatts.

You should carefully plan your switch power budget and make certain not to oversubscribe the power 
supply.

When you manually configure the power budget, you must also consider the power loss over the cable 
between the switch and the powered device.

When you enter the power inline consumption default wattage or the no power inline consumption 
default global configuration command, or the power inline consumption wattage or the no power 
inline consumption interface configuration command this caution message appears:

%CAUTION: Interface interface-id: Misconfiguring the 'power inline consumption/allocation' 

command may cause damage to the switch and void your warranty. Take precaution not to 

oversubscribe the power supply.Refer to documentation.

If the power supply is over-subscribed to by up to 20 percent, the switch continues to operate but its 
reliability is reduced. If the power supply is subscribed to by more than 20 percent, the short-circuit 
protection circuitry triggers and shuts the switch down.

For more information about the IEEE power classifications, see the