Netgear GSM7228PS-100NAS 사용자 설명서

Using CLI Help

Enter a question mark (?) at the command prompt to display the commands available in the 
current mode. 

(switch) >?

enable                   Enter into user privilege mode.

help                     Display help for various special keys.

logout                   Exit this session. Any unsaved changes are lost.

ping                     Send ICMP echo packets to a specified IP address.

quit                     Exit this session. Any unsaved changes are lost.

show                     Display Switch Options and Settings.

telnet                   Telnet to a remote host.

Enter a question mark (?) after each word you enter to display available command keywords 
or parameters.

(switch) #network ?

javamode                 Enable/Disable.

mgmt_vlan                Configure the Management VLAN ID of the switch.

parms                    Configure Network Parameters of the router.

protocol                 Select DHCP, BootP, or None as the network config

                         protocol.

If the help output shows a parameter in angle brackets, you must replace the parameter with 
a value.

(switch) #network parms ?

<ipaddr>                 Enter the IP address.

If there are no additional command keywords or parameters, or if additional parameters are 
optional, the following message appears in the output:

<cr>                     Press Enter to execute the command

Ctrl-Y

Prints last deleted character

Ctrl-Q

Enables serial flow

Ctrl-S

Disables serial flow

Ctrl-Z

Return to root command prompt

Tab, <SPACE>

Command-line completion

Exit

Go to next lower command prompt

?

List available commands, keywords, or parameters