Netgear GSM7228PS-100NAS 사용자 설명서

You can also enter a question mark (?) after typing one or more characters of a word to list 
the available command or parameters that begin with the letters, as shown in the following 
example:

(switch) #show m?

mac-addr-table           mac-address-table        monitor

Accessing the CLI

You can access the CLI by using a direct console connection or by using a telnet or SSH 
connection from a remote management host. 

For the initial connection, you must use a direct connection to the console port. You cannot 
access the system remotely until the system has an IP address, subnet mask, and default 
gateway. You can set the network configuration information manually, or you can configure 
the system to accept these settings from a BOOTP or DHCP server on your network. For 
more information, see 

638.