Netgear GSM7228PS-100NAS 사용자 설명서
Management Commands
714
ProSafe Managed Switch
set clibanner
Use this command to add the CLI Banner. The banner message supports up to 2000
characters.
characters.
Format
set clibanner <line>
Mode
no set clibanner
Use this command to remove the CLI Banner downloaded through TFTP.
Format
no set clibanner
Mode
Switch Database Management (SDM) Templates
You can use SDM templates to configure system resources in the switch and optimize
support for specific features depending on how the switch is used in the network. You can
select a template to provide the maximum system usage for a specific function. For example,
you could use a routing template to optimize resources for IPv4 routing if the network
environment does not use IPv6 routing.
support for specific features depending on how the switch is used in the network. You can
select a template to provide the maximum system usage for a specific function. For example,
you could use a routing template to optimize resources for IPv4 routing if the network
environment does not use IPv6 routing.
Note the following:
•
If you configure an SDM template, you must reload the switch for the configuration to take
effect.
•
If you try to configure IPv6 routing without first selecting the dual IPv4-IPv6 routing
template, a warning message appears.
sdm prefer
Use this command to specify the SDM template to use on the switch.
Default
Format
sdm prefer {ipv4-routing {data-center {enterprise|plus-enterprise} |
enterprise} | dual-ipv4-and-ipv6 {data-center-enterprise |
enterprise}}
Mode
Note:
This command is not supported on the following legacy switches:
GSM7328S V2H1,GSM7352 V2H1,GSM7228PS V1H1, and
GSM7228PS V1H1.
GSM7228PS V1H1.
Global Config
Global Config
ipv4-routing for IPv4 only builds, dual-ipv4-ipv6 for IPv6 builds
Global Config