Netgear M4100-50G 사용자 설명서
Utility Commands
611
ProSafe M4100 and M7100 Managed Switches
clear ip address-conflict-detect
This command clears the detected address conflict status information.
Format
clear ip address-conflict-detect
Mode
Link Local Protocol Filtering Commands
Link Local Protocol Filtering (LLPF) allows the switch to filter out multiple proprietary protocol
PDUs, such as Port Aggregation Protocol (PAgP), if the problems occur with proprietary
protocols running on standards-based switches. If certain protocol PDUs cause unexpected
results, LLPF can be enabled to prevent those protocol PDUs from being processed by the
switch. These commands are not supported on M4100 switches.
PDUs, such as Port Aggregation Protocol (PAgP), if the problems occur with proprietary
protocols running on standards-based switches. If certain protocol PDUs cause unexpected
results, LLPF can be enabled to prevent those protocol PDUs from being processed by the
switch. These commands are not supported on M4100 switches.
llpf blockall
Use this command to block LLPF protocol(s) on a port. Use
blockall
to filter all PDUs with a
DMAC of 01:00:00:0C:CC:CX on the interface. Use
blockisdp
to filter the ISDP packets on
the interface. Use
blockvtp
to filter the VTP packets on the interface. Use
blockdtp
to filter
the DTP packets on the interface. Use
blockudld
to filter the UDLD packets on the interface.
Use
blockpagp
to filter the PAGP packets on the interface. Use
blocksstp
to filter the SSTP
packets on the interface.
Format
llpf {blockisdp | blockvtp | blockdtp | blockudld | blockpagp
| blocksstp | blockall }
Mode
Default
no llpf
Use this command to unblock LLPF protocol(s) on a port.
Last Conflicting
MAC Address
MAC Address
The MAC Address of the conflicting host that was last detected on any interface.
Time Since
Conflict
Detected
Conflict
Detected
The time in days, hours, minutes and seconds since the last address conflict was
detected.
detected.
Privileged EXEC
Interface Config
Disable
Term
Definition