Netgear M4100-50G Manuel D’Utilisation

This command clears the detected address conflict status information.

clear ip address-conflict-detect

Link Local Protocol Filtering Commands

Link Local Protocol Filtering (LLPF) allows the switch to filter out multiple proprietary protocol 
PDUs, such as Port Aggregation Protocol (PAgP), if the problems occur with proprietary 
protocols running on standards-based switches. If certain protocol PDUs cause unexpected 
results, LLPF can be enabled to prevent those protocol PDUs from being processed by the 
switch. These commands are not supported on M4100 switches.

Use this command to block LLPF protocol(s) on a port. Use 

blockall

 to filter all PDUs with a 

DMAC of 01:00:00:0C:CC:CX on the interface. Use 

blockisdp

 to filter the ISDP packets on 

the interface. Use 

blockvtp

 to filter the VTP packets on the interface. Use 

blockdtp

 to filter 

the DTP packets on the interface. Use 

blockudld

 to filter the UDLD packets on the interface. 

Use 

blockpagp

 to filter the PAGP packets on the interface. Use 

blocksstp

 to filter the SSTP 

packets on the interface.

llpf {blockisdp | blockvtp | blockdtp | blockudld | blockpagp

| blocksstp | blockall }

Use this command to unblock LLPF protocol(s) on a port. 

The MAC Address of the conflicting host that was last detected on any interface.

The time in days, hours, minutes and seconds since the last address conflict was 
detected.

Privileged EXEC

Interface Config

Disable