Netgear WFS709TP-100NAS 사용자 가이드

2-1

This chapter describes how to connect a WFS709TP ProSafe Smart Wireless Switch and access 
points (APs) to your wired network.

It includes the following topics:

•

•

•

•

This section describes the tasks you need to perform in connecting a WFS709TP and APs to your 
wired network in three typical deployment scenarios.

In the deployment scenario shown in 

, the APs and WFS709TP are on the same 

subnetwork and will use IP addresses assigned to the subnetwork. There are no routers between 
the APs and the WFS709TP; APs can be physically connected directly to the WFS709TP. The 
uplink port on the WFS709TP is connected to a Layer 2 switch or router.

You need to perform the following tasks:

1. Run the initial setup (see