Netgear WFS709TP-100NAS 사용자 가이드

2-2

Deploying a Basic WFS709TP System

•

Set the IP address of VLAN 1.

•

Set the default gateway to the IP address of the interface of the upstream router to which 
you will connect the WFS709TP.

2. Connect the uplink port on the WFS709TP to the switch or router interface. By default, all 

ports on the WFS709TP are access ports and will carry traffic for a single VLAN.

3. Deploy the APs. The APs will use the ADP protocol to locate the WFS709TP.

You would then configure the SSIDs with VLAN 1 as the assigned VLAN for all users.