Netgear 7000 Series 사용자 설명서

Managing Switch Stacks

20-9

You manage the switch stack and the stack member interfaces through the stack master. You can 
use the web interface, the CLI, and SNMP. You cannot manage stack members on an individual 
switch basis.

You can connect to the stack master through the console port of the stack master only.

You can connect to the stack master by using a Telnet connection to the IP address of the stack.

 provides switch stack configuration scenarios. Most of the scenarios assume at least 

two switches are connected through their stacking ports.

Stack master election specifically determined by 
existing stack masters
Note: This is not recommended.
• Connect two powered-on switch stacks through the 

stacking ports.

Only one of the two stack masters becomes the new 
stack master. None of the other stack members 
become the stack master.

Stack master election specifically determined by the 
stack member priority value
• Connect two switches through their stacking ports.
• Use  the  switch stack-member-number priority 

new-priority-number global configuration command 
to set one stack member to a higher member 
priority value.

• Restart both stack members at the same time.

The stack member with the higher priority value is 
elected stack master.