Avaya P332MF 사용자 설명서

Chapter 6

CLI – Layer 2

Avaya P332MF User’s Guide

93

The protocol has been set to TIME protocol 

The

 set time server 

command is used to set the TIME server address.

The syntax for this command is:

set time server <ip>

The

 set time client 

command is used to enable or disable the periodic 

network time acquisition by the switch from the network time server (SNTP or 
TIME protocol). 

The syntax for this command is:

set time client <enable|disable>

Use the

 set ip route 

command to add IP addresses to the IP routing table. You 

can configure from one to ten (10) default gateways for a P330 stack.

The syntax for this command is:

set ip route <destination> <gateway>

Output Example:
This example shows how to add a default route to the IP routing table:

P330-N# set ip route 

0.0.0.0

 

192.168.1.1

destination = 0.0.0.0  gateway = 192.168.1.1

ROUTE NET TABLE

destination      gateway          flags  Refcnt  Use           Interface

------------------------------------------------------------------------

0.0.0.0          192.168.1.1      1      1       3199          se0

127.1.1.0        127.1.1.1        1      8       7606          se1

------------------------------------------------------------------------

ip

IP address of the TIME server.

destination

IP address of the network, or specific host to be added

gateway

IP address of the router