Avaya P332MF 사용자 설명서
Chapter 6
CLI – Layer 2
Avaya P332MF User’s Guide
95
Output Example:
To enable SNMP ConfigChange traps to a specific manager:
To enable SNMP ConfigChange traps to a specific manager:
P330-N# set snmp trap 192.168.173.42 enable config
SNMP config change traps enabled.
Output Example:
To enable all traps to a specific manager:
To enable all traps to a specific manager:
P330-N# set snmp trap 192.168.173.42 enable all
All SNMP traps enabled.
Output Example:
To disable SNMP config traps to a specific manager:
To disable SNMP config traps to a specific manager:
P330-N# set snmp trap 192.168.173.42 disable config
SNMP config traps disabled.
Output Example:
To add an entry in the SNMP trap receiver table with default:
To add an entry in the SNMP trap receiver table with default:
P330-N# set snmp trap 192.168.173.42
SNMP trap receiver added.
set snmp trap auth
Use the
set snmp trap auth
commands to enable/disable the sending of
SNMP traps upon SNMP authentication failure.
The syntax for this command is:
set snmp trap {enable|disable} auth
Output Example:
P330-N# set snmp trap enable auth
Authentication trap enabled
set snmp retries
Use the
set snmp retries
command to set the number of retries initiated by
the Device Manager application when it tries to send SNMP messages to the device.
The syntax for this command is:
set snmp retries <number>