Avaya P332MF 사용자 설명서

Chapter 6

CLI – Layer 2

Avaya P332MF User’s Guide

115

Use the set leaky-vlan command to define the P330 stack’s leaky VLAN mode. In 
this mode, VLAN test is done only on broadcast/multicast/unknown frames, and 
not on unicast frames. 

The syntax for this command is:

set leaky-vlan <enable|disable>

Output Example:

P330-N# set leaky-vlan enable

Leaky VLAN mode enabled

Use the

 set spantree 

command to enable/disable the spanning-tree protocol 

for the stack.

When you disable STP, blocking ports are disabled in order to prevent loops 

in the network. As a result, you should wait 30 seconds before disabling STP if you 
reset the switch, enabled STP, or inserted a new station. 

The syntax for this command is:

set spantree {enable|disable}

Output Example:

P330-N# set spantree enable

bridge spanning tree enabled.

Use the

 set spantree priority 

command to set the bridge priority for STP.

The syntax for this command is:

set spantree priority <value>

value

Number representing the priority of the bridge with a priority 
level from 0 to 65535, with 0 indicating high priority and 65535 
indicating low priority.