Avaya P880 사용자 설명서

610-0184-095

 22

June 14, 2001

state is set to Enable (all multicasts included). If you do not want to 
enable rate limiting of multicast traffic on a port, either:

■

Disable Intelligent Multicasting

■

Disable Rate-limiting on the port.

The following problems have no workaround: 

■

If you create overlapping IP interfaces (interfaces in the same 
subnet), the state of the second interface is INACTIVE.

■

If you enter a non-numeric value in either the Network 
Address or Mask fields on the IP Static Route page, all of the 
numbers are rejected and the field converts back to 0.

802.3 IPX routed frames are sometimes padded in such a way that 
they are incompatible and discarded by older IPX clients and drivers.

Use newer client software (v2.5 or later) or use a frame format other 
than 802.3 (Avaya recommends that you use format 802.2). If you 
cannot use new client software or a newer frame format, use the 
following CLI commands to allow 802.3 IPX clients to connect:

■

ƒIPX Forward Set

■

ƒIPX Forward Get

Refer to the Cajun P550R/P880/P882 Switch Command Line Reference 
guide for more details about these new commands.

Attempting to change the maximum number of entries in the L3 
Forwarding Cache while you are using a licensed 80-Series module 
will cause the switch to stop responding, if the switch is configured 
with 10,000 entries or more. The CLI or the Web interface will not 
respond and the scrolling text on the supervisor will stop.