ZyXEL Communications XGS-4526 사용자 설명서

Chapter 8 Basic Setting

XGS-4526/4528F/4728F User’s Guide

Use the IP Setup screen to configure the default gateway device, the default 
domain name server and add IP domains. 

The Switch needs an IP address for it to be managed over the network. The 
factory default IP address is 192.168.1.1. The subnet mask specifies the network 
number portion of an IP address. The factory default subnet mask is 
255.255.255.0.

On the Switch, as a layer-3 device, an IP address is not bound to any physical 
ports. Since each IP address on the Switch must be in a separate subnet, the 
configured IP address is also known as IP interface (or routing domain). In 
addition, this allows routing between subnets based on the IP address without 
additional routers. 

You can configure multiple routing domains on the same VLAN as long as the IP 
address ranges for the domains do not overlap. To change the IP address of the 

Level 4

Typically used for controlled load, latency-sensitive traffic such as SNA 
(Systems Network Architecture) transactions.

Level 3

Typically used for “excellent effort” or better than best effort and would 
include important business traffic that can tolerate some delay.

Level 2

This is for “spare bandwidth”. 

Level 1

This is typically used for non-critical “background” traffic such as bulk 
transfers that are allowed but that should not affect other applications 
and users. 

Level 0

Typically used for best-effort traffic.

Apply

Click Apply to save your changes to the Switch’s run-time memory. The 
Switch loses these changes if it is turned off or loses power, so use the 
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

Table 12   Basic Setting > Switch Setup  (continued)