Allied Telesis AT-8000S 사용자 설명서
Page 44
Allied Telesis AT-8000SSwitch
Installation Guide
Warning
13. Do not strip more than the recommended amount of wire. Stripping more than the recommended
amount can create a safety hazard by leaving exposed wire on the terminal block after installation.
amount can create a safety hazard by leaving exposed wire on the terminal block after installation.
Warning
14. When installing this equipment, always ensure that the frame ground connection is installed first and
disconnected last.
disconnected last.
Warning
15. Check to see if there are any exposed copper strands coming from the installed wire. When this
installation is done correctly there should be no exposed copper wire strands extending from the terminal
block. Any exposed wiring can conduct harmful levels of electricity to persons touching the wires.
installation is done correctly there should be no exposed copper wire strands extending from the terminal
block. Any exposed wiring can conduct harmful levels of electricity to persons touching the wires.
Warning
17. This system works with positive grounded or negative grounded DC systems.
Warning
18. Only trained and qualified personnel are allowed to install or to replace this equipment.
Caution
19. The attached mounting brackets must be used to securely mount the device on the wall.
Caution
20. Do not install in direct sunlight, or a damp or dusty place.
Caution
21. Do not expose the gateway device to moisture or water.
Caution
22. If the gateway device is installed indoors, make sure that the site is a dust free environment. The site
should provide for easy access to the ports of the gateway device.This will make it easy for you to connect
and disconnect cables, as well as view the LEDs.
should provide for easy access to the ports of the gateway device.This will make it easy for you to connect
and disconnect cables, as well as view the LEDs.