Allied Telesis AT-8000S 사용자 설명서
Safety Statements
Electrical Safety Notices
Page 45
Warning
23. The power source for the gateway unit should be located near the unit and should be easily accessible.
Caution
24. To allow proper cooling of the gateway device, make sure that the air flow around the unit and through
its heatsink cooling fins on the rear is not restricted.
its heatsink cooling fins on the rear is not restricted.
Caution
25. Circuit Overloading: Consideration should be given to the connection of the equipment to the supply
circuit and the effect that overloading of circuits might have on overcurrent protection and supply wiring.
Appropriate consideration of equipment nameplate ratings should be used when addressing this concern.
circuit and the effect that overloading of circuits might have on overcurrent protection and supply wiring.
Appropriate consideration of equipment nameplate ratings should be used when addressing this concern.
Caution
26. Risk of explosion if battery is replaced by an incorrect type. Replace only with the same or equivalent
type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s
instructions.
type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s
instructions.
Attention: Le remplacement de la batterie par une batterie de type incorrect peut provoquer un danger
d’explosion. La remplacer uniquement par une batterie du même type ou de type équivalent recommandée par le
constructeur. Les batteries doivent être éliminées conformément aux instructions du constructeur.
d’explosion. La remplacer uniquement par une batterie du même type ou de type équivalent recommandée par le
constructeur. Les batteries doivent être éliminées conformément aux instructions du constructeur.
Warning
27. For centralized DC power connection, install only in a restricted access area.
Warning
28. A tray cable is required to connect the power source if the unit is powered by centralized DC power.
The tray cable must be a UL listed Type TC tray cable and rated at 600 V and 90 degrees C, with three
conductors, minimum 14 AWG.
The tray cable must be a UL listed Type TC tray cable and rated at 600 V and 90 degrees C, with three
conductors, minimum 14 AWG.
Warning
29. Mounting of the equipment in the rack should be such that a hazardous condition is not created due
to uneven mechanical loading.
to uneven mechanical loading.