Intermec PF4i 사용자 설명서

  If you have chosen either DHCP+BOOTP, DHCP, or BOOTP, press 

the  key and you can read the temporary IP address automatically 

assigned by the server, for example:

  After having read the IP address, press the <Enter> key to go on to 

Netmask parameter or press the <Setup> key to exit the Setup Mode.

These parameters work in the same way as reading the IP address. In 

case of DHCP, BOOTP, or DHCP+BOOTP, these parameters are set 

automatically by the server. In case of the ARP’n’PING method, you will 

have to set these parameters via the printer’s home page once the network 

communication has been established. 

The ARP’n’PING method is intended for networks that do not have an 

DHCP or BOOTP server. 
You must have a free IP address, which will be permanently assigned to 

the printer. However, it could be changed later from the printer’s home 

page once the communication is established.
You must also have the printer’s MAC address. You can get the MAC 

address from the Setup Mode as shown above or from the serial number 

label on the EasyLAN board.
If the printer is started with DHCP and/or BOOTP, the printer will try 

to find an IP address five times before it considers it a failure. This takes 

about 2 minutes during which you cannot start using the ARP’n’PING 

method.
The following instructions apply to Windows 2000, but similar methods 

can be used on other operating systems, both in Windows and in Unix. 

In Windows, the groups of digits in the MAC address are separated by 

hyphens (-), and in Unix by colons (:).