Intermec PF4i 사용자 설명서

MANUAL mode is only supported by IPL 2.40 or later.

You can use MANUAL mode to assign a static IP address to the printer.
To assign network values manually, connect the printer to the serial 

port on the host PC and open a communications program such as 

HyperTerminal. Send this command:

<SI>nn[,m1[,m2]]

where:
n is the IP address, in the format n.n.n.n, where n is a number in the 

range 0-255.
,m1 is the subnet mask address written in the same format.
,m2 is the router address written in the same format.
Sending this command places the printer in MANUAL mode 

automatically if you specify at least two of the three parameters. If you 

specify only one parameter, such as the IP address, you need to place the 

printer in MANUAL mode via the printer's keyboard before you send 

the command. Otherwise, the command will have no effect.
You can confirm the IP address by sending the upload configuration 

parameters command.
Examples:

Sets the IP address to 192.168.235.86, the subnet mask to 

255.255.254.0, and the router to 192.168.234.1.

Sets the IP address to 192.168.235.86 and uses the default subnet mask 

and router settings. You need to place the printer in MANUAL mode via 

the printer's keyboard before you send this command.