HP (Hewlett-Packard) 10 사용자 설명서

Deployment tasks 23

Rapid Deployment Pack

When deploying Solaris using Rapid Deployment Pack, a small, non-Solaris partition is created on the

boot volume to facilitate booting the installation. By default, Solaris avoids disks with existing partitions,

so this temporary partition must be deleted. This deletion can be accomplished using the

fdisk

profile

keyword to delete all type 0x83 partitions. You must create a new Solaris partition to replace the 0x83
partitions. For example:

fdisk rootdisk 0x83 delete

fdisk rootdisk solaris all

Example: JumpStart preparation

This section provides a complete JumpStart example. In this example, the profile is named “proliant,” and
the entire Solaris distribution is installed, along with the

CPQary3

and

BRCMbnx

packages. Optional

configuration for use with Rapid Deployment Pack is also listed. If installing to disks attached to a Smart

Array controller, the root disk must be SCSI target 0, LUN 0 (that is,

cxt0d0

NOTE:

The example sysidcfg(4) file contains entries that are new to Solaris 10 11/06 and might not

be supported by previous releases.

Prepare the configuration files as follows:

○

Contents of the directory structure:

/jumpstart/

/jumpstart/rules

/jumpstart/proliant

/jumpstart/sysidcfg

○

Contents of the

rules

file:

arch i386 - proliant -

○

Contents of the

proliant

file:

install_type initial_install

system_type standalone

partitioning default

cluster SUNWCXall

package CPQary3 add nfs://

jssip

/jumpstart/pkg

package BRCMbnx add nfs://

jssip

/jumpstart/pkg

where

jssip

is the IP address of the JumpStart server.

If using Rapid Deployment Pack, also include the following lines:

fdisk rootdisk 0x83 delete

fdisk rootdisk solaris all