Emerson XDF 사용자 설명서

The XDF’s doors are removable for convenience when installing equipment.

1. Remove the bolts securing the lower half of 

each two-piece hinge to the door.

2. Remove the lower half of each hinge.
3. Lift the door straight up until the pins clear 

the hinges.

4. Set the door in a safe place.

For minimum-security installations that also 

require frequent and fast removal of the door, the 

lower half of the hinge assembly may be perma-

nently removed. This allows for quick removal of 

an open door by lifting the door straight up until 

the pins clear the hinge mount.

XDF side panels are simple to remove and replace, 

making it easier to install equipment and to ser-

vice the XDF. Panel removal also improves access 

for equipment maintenance and replacement.

To remove the left panel from the XDF:
1. The left panel is secured with two internal security quarter-turn fasteners and four panel 

retainers. Open the doors and locate the internal security quarter-turn fasteners on the left side 

panel. The security fasteners are at the top front and top rear corners of the panel.

2. Using the factory-supplied T-handle Allen wrench, turn the internal security fasteners 

counterclockwise 90 degrees.

3. Locate the four panel retainers on the outside of the left XDF panel. One retainer is in each corner 

of the panel.

4. Using the factory-supplied T-handle Allen wrench, turn the panel retainers counterclockwise 

90 degrees.

5. Lift the panel off the lip at the bottom of the XDF and set it in a safe location.

Risk of electric shock. Can cause injury or death.
Disconnect all local and remote electric power before working within and/or installing 

equipment.

Risk of heavy panel falling off. Can cause injury and/or equipment damage.
Support the panel when removing it. Unlocking the security fasteners and removing the panel 

retainers will allow unsupported panel to fall.