Uniden UBC92XLT 사용자 설명서
27
Operation
Operation
Turning On The Scanner and
Setting Squelch
Setting Squelch
Note: Make sure the scanner's antenna is
connected before you turn it on.
connected before you turn it on.
1. Turn Squelch fully counterclockwise.
2. Press and hold
for about 2 seconds to turn
the scanner on, then turn Volume clockwise until
you hear a hissing sound.
you hear a hissing sound.
3. If the scanner is scanning, press Hold to stop
scanning, then turn Squelch clockwise until the
hissing stops.
hissing stops.
Storing Known Frequencies
Into Channels
Into Channels
1. Press Hold. Then enter the channel number
where you want to store a frequency, then press
Func and Pgm. The channel number appears.
Func and Pgm. The channel number appears.
2. Use the number keys and /Clr to enter the
frequency (including the decimal point) you want
to store.
to store.
3. Press E to store the frequency into the channel.
Notes:
Notes:
•
If you entered an invalid frequency in Step 2,
Error
Error
appears and the scanner beeps three
times. Enter a valid frequency.
•
The scanner automatically rounds the entered
number to the nearest valid frequency.
For example, if you enter 28.473 (MHz), your
scanner accepts it as 28.475.
number to the nearest valid frequency.
For example, if you enter 28.473 (MHz), your
scanner accepts it as 28.475.
•
When you enter a frequency into a channel, the
scanner automatically turns on the delay
function and DLY appears. When delay is turned
on, the scanner automatically pauses scanning
scanner automatically turns on the delay
function and DLY appears. When delay is turned
on, the scanner automatically pauses scanning
UB324 Paper OM reduced size.fm Page 27 Wednesday, February 2, 2005 8:01 PM