Uniden BCT15 사용자 설명서

70

To see the last Firmware Version, as well as the electronic serial number:

 

 Settings 

 

F

 

 

 See Scanner Info 

 

F

 

 

 Firmware Version 

 

F

 

The version number in the format X.XX.XX appears on the top line of the display 
while the serial number shown as SNXXXXXXXXXXXXXX appears at the bottom.

 

Important: record the serial number in a secure place should you have a need to 
identify your scanner at some time. Press any key to return to the previous menu.

Follow these steps to clear the memory.

Warning: This clears data you have entered. You cannot restore user 
programmed data that has been deleted. 

1.

To initialize the scanner’s memory, turn off the scanner.

2.

While pressing [2], [9], and [HOLD] at the same time, turn on power.

At that point anything you have programmed is gone.

You can use the supplied cable to connect your 
scanner to a personal computer to download data 
from the computer to the memory of the scanner or 
control the scanner’s operation. Before you proceed, 
you must first set the scanner’s communications 
speed as described in the “Setting the Serial Port 
Speed” section. In addition you will need a copy of 
Uniden Advanced Scanner Director software. You can 
download the software from http://www.uniden.com in the Customer Service 
downloads link. However, you must purchase an Unlocking Key from your Uniden 
dealer to unlock the software’s full functionality.

Important: Start with a high baud rate setting. If, during transfer, you get an error 
message, reduce the setting in the software and the scanner and start again until 
you get reliable, complete transfer of data.