Uniden BCT15 사용자 설명서

71

If you use a PC to control the scanner, and you change the scanner’s volume or 
squelch setting using the PC, the scanner ignores the front-panel control’s current 
setting. However, if you later change the volume or squelch setting using the 
front-panel control, the scanner uses the control’s setting (i.e. the scanner pays 
attention to the last method used).

Using the scanner in a cloning setup lets you transfer programmed data directly 
from a source or master BCT15 to a target or slave BCT15. Wired cloning 
between other models to the BCT15 is not possible.

[MENU] 

 

 Wired Clone 

 

F

 

 

 Master or Slave (select one as the master and one as the slave)

To clone (transfer) data directly from one BCT15 scanner to another BCT15 
scanner, you must first connect the scanners to each other using the included 
connection cable. Then you must set one scanner as the source and the other as 
the target.

1.

Plug the smaller end of the included connection cable into the Front Port. Then 
connect the DB9 end of the cable into the Rear Port. Be sure to set the 
scanner using the Front Port to Front and the other unit to Rear when 
making the speed selection.

2.

Set the scanner containing the programming you want to transfer as the 
master scanner, then set the other scanner as the slave scanner.

3a. (Master scanner) Clone Master Press SCAN Key 

 [SCAN/SEARCH]