Uniden BCT15 사용자 설명서
73
Programming Your Scanner
Programming Your Scanner
To get the most enjoyment from your scanner, you must customize the
programming for services in your area.
programming for services in your area.
To edit an existing system, use the menu to navigate to the system setting you
want to change. This section assumes you are programming a new system.
want to change. This section assumes you are programming a new system.
Programming radio systems is completed in two major steps. Don’t skip either
step!
step!
1.
Plan the system.
2.
Program the system into your scanner according to the plan you prepared in
Step 1.
Step 1.
To make this easier, planning worksheets are available from Uniden’s website:
http://www.uniden.com/scanners. There you can fill out a worksheet on line and
then print it or print hardcopy to fill out as you see fit.
http://www.uniden.com/scanners. There you can fill out a worksheet on line and
then print it or print hardcopy to fill out as you see fit.
General Notes
The following tables provide you with the information to successfully perform
various steps connected with programming each of the systems: Conventional,
Motorola, EDACS, and LTR. Some operations are common to all of the systems
while some are specific to one system. Use the following tables to quickly locate
the step you want or need to perform (where required), and to which system or
systems it applies.
various steps connected with programming each of the systems: Conventional,
Motorola, EDACS, and LTR. Some operations are common to all of the systems
while some are specific to one system. Use the following tables to quickly locate
the step you want or need to perform (where required), and to which system or
systems it applies.
System Settings
System Settings
CNV
MOT
EDCS
LT
TYPE I
TYPE II
WIDE /
NARROW
SCAT
Edit Name
•
•
•
•
•
•
Edit Sys Option
•
•
•
•
•
•
Edit Site
•
•
•
•
•
Edit Group
•
•
•
•
•
Copy System
•
•
•
•
•
•
Delete System
•
•
•
•
•
•