Uniden UBC3500XLT 사용자 설명서

22

2. Install 3 AA batteries, 

matching the polarity 
symbols (+ -).

 

Set ALKALINE/Ni-MH to Ni-MH for use only with 
rechargeable batteries. Never attempt to recharge 
non-rechargeable batteries. Non-rechargeable 
batteries can get hot and can even burst if you try to 
recharge them.

3. Replace the cover.

When 

 flashes and the scanner beeps every 15 

seconds, replace the batteries.

You can also use three rechargeable batteries to power 
your scanner. Before you use rechargeable batteries, 
you must charge them. The scanner has a built-in 
circuit that lets you recharge batteries while they are in 
the scanner. To charge the batteries, set ALKALINE/
Ni-MH inside the battery compartment to NI-MH, 
install the batteries in the scanner, and connect the 
supplied AC adapter to the scanner's DC 6V jack (see 
“Using AC Power” on Page 23).

 

Do not connect the AC adapter to the scanner if 
non-rechargeable batteries (such as alkaline 
batteries) are installed in the scanner and 
ALKALINE/Ni-MH is set to NI-MH, or if you are 
unsure of the switch's position. Non-rechargeable 
batteries can get hot and can even burst if you try 
to recharge them. Before you use rechargeable 
batteries for the first time, charge them for 14 
hours to bring them to a full charge. Discharged 
batteries take about 14 hours to fully recharge.

UB347ZH.fm  Page 22  Thursday, August 31, 2006  11:57 AM