Uniden UBC3500XLT 사용자 설명서
23
Setting Up Your Scanner
If an AC adapter is connected to the scanner, the
scanner checks the condition of the installed batteries.
If the scanner is turned off and the batteries require a
full charge, Normal Charging appears as the
scanner checks the condition of the installed batteries.
If the scanner is turned off and the batteries require a
full charge, Normal Charging appears as the
batteries are recharged. When the batteries are fully
charged, Charge Complete appears.
charged, Charge Complete appears.
If no batteries are installed in the scanner, No Battery
appears. If there is a problem with the installed batteries,
Battery Error appears. If the installed batteries are
Battery Error appears. If the installed batteries are
Ni-MH batteries but ALKALINE/Ni-MH is set to
ALKALINE, Charge Off appears and the scanner
ALKALINE, Charge Off appears and the scanner
does not charge the batteries.
Removing the Display Sticker
Before you use the scanner, remove the protective
plastic sticker over the display.
plastic sticker over the display.
Using AC Power
You can power the scanner
using the supplied 6V,
800 mA AC adapter.
using the supplied 6V,
800 mA AC adapter.
To use the scanner on AC
power, plug the adapter into
6V 800 mA on the right side
of the scanner, then plug
the AC adapter into a standard
AC outlet.
power, plug the adapter into
6V 800 mA on the right side
of the scanner, then plug
the AC adapter into a standard
AC outlet.
If rechargeable batteries are installed and ALKALINE/
Ni-MH is set to NI-MH, the adapter powers the scanner
and recharges the installed batteries at the same time.
Ni-MH is set to NI-MH, the adapter powers the scanner
and recharges the installed batteries at the same time.
WARNING!
To prevent damage to Ni-MH batteries, never charge
them in an area where the temperature is above
45°C (113°F) or below 4°C (40°F).
45°C (113°F) or below 4°C (40°F).
UB347ZH.fm Page 23 Thursday, August 31, 2006 11:57 AM