Tandberg Data T40 사용자 설명서
52
Running the Library
Figure 22. The Release Tool Inserted into the Correct Hole on the Left Lower Magazine
Standby Functionality
On the front panel a standby button is available.
To activate Standby mode, press the button for a minimum of 2 seconds. The StorageLibrary will
enter a standby mode in a controlled manner. The following takes place before the StorageLibrary
goes into standby mode:
enter a standby mode in a controlled manner. The following takes place before the StorageLibrary
goes into standby mode:
1 Finish any StorageLibrary activity.
2 The power to the tape drives are switched off.
3 The display is turned off.
4 No StorageLibrary activity is allowed until the standby button is pressed again.
5 The green LED on the front will blink with short blinks- long intervals.
6 To leave the standby mode, press the standby button for 2 second. The StorageLibrary will then
restart and perform a full inventory.