DELL MD3220 사용자 설명서

Configuration: About Your Storage Array

For more information on configuring alert notifications, see "Configuring 

Alert Notifications" on page 74.
To configure e-mail alerts:

1 Open the Configure Alerts dialog by performing one of these actions:

• In the Tree view or the Table view on the 

Devices tab in the EMW, 

select a node, and then select 

Edit Configure Alerts. Go to step 3.

• In the Setup tab in the EMW, select Configure Alerts. Go to step 2.

2 Select one of the following radio buttons to specify an alert level:

• All storage arrays—Select this option to send an alert e-mail about 

events on all storage arrays.

• An individual storage array—Select this option to send an alert e-mail 

about events that occur on only a specified storage array.

These results occur, depending on your selection:
• If you selected all storage arrays, the 

Configure Alerts dialog appears.

• If you selected An individual storage array, the 

Select Storage Array 

dialog appears. Select the storage array for which you want to receive 

e-mail alerts and click 

OK. The Configure Alerts dialog appears. 

• If you do not know which storage array to select, click 

Blink to turn on 

the LEDs of the storage array. 

3 In the Configure Alerts dialog, select the Mail Server tab.
4 In Mail server, type the name of the Simple Mail Transfer Protocol 

(SMTP) mail server.
The SMTP mail server is the name of the mail server that forwards the 

alert e-mails to the configured e-mail addresses.

5 In Email sender address, type the e-mail sender address. Use a valid e-mail 

address.
The e-mail address of the sender (the network administrator) appears on 

each e-mail alert sent to the destination. 

6 To include the contact information of the sender in the e-mail alert, select 

Include contact information with the alerts, and type the contact 

information. 

book.book  Page 75  Monday, June 21, 2010  11:00 AM