Festool PAC571782 사용자 설명서

8

  This motion is recommended for sand-

ing with low material removal for a 

scratch-free fi nish (fi ne sanding).

Press the switch (6.1) downwards and push 

it into the left-hand position. 

The tool can be fi tted with three sanding pads 

of different hardnesses depending on the sur-

face to be sanded.
Hard: Coarse sanding on surfaces, sanding 

at edges.
Soft: Universal use for coarse and fi ne sand-

ing for fl at and curved surfaces.
Super-soft: Fine sanding on formed parts, 

curves, radii. Do not use on edges!

Installation 
The FastFix system enables tool-free replace-

ment of the sanding pad (7.4):
- Set the switch (7.1) to the right, to the Rotex 

rotary motion

- Press spindle stop (7.2), 
- Turn the fi tted sanding pad from the spindle 

(right-handed thread)

- Keep the spindle stop pressed and screw 

on the new sanding pad (in doing so, make 

sure that the rubber collar (7.3) is correctly 

fi tted!). 

- Let go of the spindle stop. 

 Actuate the spindle stop only when 

the drive spindle is stationary. Do not switch 

on the motor when the spindle stop is pressed 

in.

 Stickfi x is a hook-and-loop fastening 

system. Stickfi x sanding pads allow 

the use of self-adhesive hook-and-loop 

abrasives such as Stickfi x sandpapers 

and sanding cloths. 

Simply press the abrasive onto the sanding 

pad and pull it off again after use.