Shindaiwa HT2510 사용자 설명서

6

Starting Procedure

.  Set the throttle trigger to the “fast idle” 

position by performing the following:

  a.  Depress and hold the throttle lock, 

and then squeeze the throttle trigger.

  b.  Depress and hold the “fast idle”  

button.

  c.  While depressing the fast idle button, 

release the throttle lock and throttle 

trigger.

3.  Prime the carburetor by repeatedly 

depressing the carburetor primer bulb 

until clear fuel can be seen flowing 

through the transparent primer bulb.

WARNING!

n  Place the trimmer on the ground 

during all starting operations.

n  Make sure you have a secure foot-

ing, and keep a firm grip on the unit 
as well.

n  Keep all bystanders and pets well 

clear of the trimmer during starting 
operations.

IMPORTANT!

Engine ignition is controlled by a two-position on-off switch mounted on the throttle 
body. This switch is typically labeled 

“I” for ON and  “O” for OFF.

n

Repeat the appropriate starting proce-

dure for a cold or warm engine.

n

If the engine still fails to start, use  

the procedures for “Starting a flooded 

engine,” on the next page.

WARNING!

The cutting attachment will move when 
the engine accelerates!

1.  Open the choke by moving the choke 

lever backward (toward the fuel tank).

.  If the engine does not continue to run, 

repeat the appropriate cranking proce-

dures for a cold or warm engine.

3.  When the engine starts, clear excess 

fuel from the combustion chamber by 

accelerating the engine several times 

with the throttle lever.

4.  Operating the throttle will automatically 

disengage the fast idle setting.

1.  Place the unit on the ground. Grip the 

engine cover with your left hand and 

the starter handle with your right hand 

(shown).

.  Pull the starter handle slowly toward 

you until you feel the starter mechanism 

engage.

3.  Start the trimmer by pulling the starting 

handle rapidly outward.

1.  Move the ignition stop switch to the rear 

(towards the grip) to the “I” or ON posi-

tion. See Figure 4.

4. 

(Cold engine only) Choke the engine 

by moving the choke lever forward to 

the “closed” position. See Figure 7.

IMPORTANT! 

The primer system only pushes fuel through 
the carburetor. Repeatedly pressing the 

primer bulb will not flood the engine with fuel.

n

  Squeezing the throttle increases engine 

speed, causing the clutch to engage and 

operate the cutters.

n

  Releasing the throttle decreases  

engine speed, causing the cutters to 

slow, and then stop altogether as the 

clutch disengages.

n

  Use a sweeping motion when cutting, 

and vary throttle settings often.

n

  Avoid cutting material larger than  

1.7 cm in diameter.

CAUTION!
The recoil starter can be easily
damaged by abuse!

n  Always engage the starter before 

attempting to crank the engine.

n  Never pull the starter cord to its full 

length.

n  Always rewind the starter cord 

slowly.