Shindaiwa HT2510 사용자 설명서

다운로드
페이지 48
8
Throttle 
Cable 
Adjuster
Throttle 
Cable 
Adjuster 
Lock Nut
Throttle 
Cable 
Figure 15
Maintenance and Adjustments
IMPORTANT!
Maintenance, replacement or repair of 
emission control devices and systems 
may be performed by any repair estab-
lishment or individual; however, warranty 
repairs must be performed by a dealer or 
service center authorized by Shindaiwa 
Corporation. The use of parts that are not 
equivalent in performance and durability to 
authorized parts may impair the effective-
ness of the emission control system and 
may have a bearing on the outcome of a 
warranty claim.
WARNING!
Accidental start-ups can cause severe 
injury! Before performing any main-
tenance on this equipment, stop the 
engine and disconnect the spark plug!
1.  Remove all grass clippings and dirt from 
the hedge trimmer.
  n  Remove any compacted debris from 
around the fuel tank and/or muffler.
  n  Inspect the engine cooling fins for 
clogging, and clean as necessary.
  n   Clean under the cylinder cover and 
around the spark plug.
  n   Inspect the air filter element for clog-
ging, clean as necessary.
Clean debris from 
tank and muffler
Inspect cooling 
fins, and clean as 
required
Clean around 
spark plug
Inspect/clean 
air filter  
element
Check cutters and 
guide bar for damage 
and that bolts 
are tight
Lubricate 
cutters
WARNING!
To reduce fire hazard, keep the engine 
and muffler free of debris, leaves, or 
excessive grease.
Keep cooling 
fins clean
Keep cooling air 
intake passages 
clean
(Fuel tank removed 
for clarity)
Daily Maintenance/Inspection
Figure 12
.  Check for loose, damaged, or missing 
components, and repair as necessary.
3.  Lubricate the cutters with oil before use, 
and after refueling.
4.  Check the cutters for damage and make 
sure all bolts are tight.
Inspect front and rear handles for 
damaged or loose attachments
Figure 13
If the unit does not return to idle speed or 
doesen't reach full rpm, the throttle lever 
free play may need to be adjusted as follows:
1.  Measure free play at the end of the 
throttle lever. Throttle lever free play 
should be approximately 0.-0.75"         
(5-7 mm). See Figure 14. 
.   If adjustment is necessary, remove the 
air cleaner cover by loosening the two 
thumbscrews. Loosen the cable adjuster 
lock nut and turn the cable adjustment 
fitting in or out until throttle lever free 
play is approximately 0.-0.75" (5-7 
mm).
3.  Replace the air cleaner cover, and tight-
en the cover retaining screws securely.
Assembly and Adjustments
 
Throttle Cable Free Play
0.2-0.275"      
(5-7mm)
0.2-0.275"      
(5-7mm)
Throttle Lever
Free Play
Figure 14